Integrating STOBER Drives Hollow Bore Motors into Your Kinetix System

STOBER’s EZHD, EZHP, and EZM are all Rockwell Enabled. They work with the Kinetix 6500 Version 23 and up as well as the Kinetix 5700 Version 2 and up. They utilize Heidenhein Endat 2.2 digital single turn absolute positioning.

To enable the motor, choose the correct STOBER motor from the drop-down menu. On the feedback tab, choose alignment = motor offset. This will trigger the drive to use the commutation offset that is stored in the nameplate.

If you wish to test the motor, you can highlight the motion group you are using and select motion direct commands. Select the command you want to use and click execute to start the command.

If you need any assistance, please contact STOBER at 606-759-5090.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s